Go to main content

Mirror Extenders - Instructions

These extenders are universal and will fit M10x1.25 thread. Supplied bolt is M10x1.25 and will fix your extender to the handlebars.

Warning: Our parts are made out of aluminum and are anodized black for looks and protection. If some markings occur after installation, simply touch them up with magic marker or paint.

You can purchase our mirror extenders here

You will need:

Tools needed

14MM open end wrench

1/2 open end wrench

1/4 allen wrench

Motorcycle mirror extenders for RAM or GoPro
Start of the installation

1

Start of the installation

Locate the connection between the mirror and the handlebars

2

Locate the connection between the mirror and the handlebars

Move the RUBBER COVER up

3

Move the RUBBER COVER up

Loosen up the JAM NUT

4

Loosen up the JAM NUT by rotating the wrench clockwise (CW / right) direction since it is the left-hand thread. Use 14MM open-end wrench

Start of the installation

5

Using the same wrench - loosen up the STEM that connects your mirror with the handlebars. This time turn the wrench counter-clockwise (CCW / left).

Rotate the stem left

6

When the JAM NUT and the STEM are loosened up - rotate the stem left (CCW) until the STEM comes off the mirror and the handlebars.

Ready to install your new MIRROR ETENDERS

7

At this point, everything should be separated and ready to install your new MIRROR ETENDERS

Attach MIRROR EXTENDER

8

Attach MIRROR EXTENDER to the handlebars with provided M10x1.25 bolt. Set it at the desired angle and tighten it with a 1/4 Allen wrench.

Screw in the STEM

9

Screw in the STEM just a few rotations into your MIRROR EXTENDER

Rotate the stem left

10

Make sure that the JAM NUT is all the way up on the mirror thread. Place the threaded end of the mirror on top of the STEM and start turning the STEM in the CLOCKWISE directions (right). Everything should come together. Tighten up THE STEM to the MIRROR EXTENDER.

NOTE: if your mirror's thread bottomed out before you were able to tighten the STEM to the MIRROR extender - please back it all out and start point #10 again by screwing THE STEM a few rotations more than initially into the MIRROR EXTENDER.

Set the mirror at the desired angle

11

Set the mirror at the desired angle and tighten the JAM NUT against the STEM

Pull the rubber cover down

12

Pull the rubber cover down

Using 1/2 wrench, install the 1-inch BALL.

13

Using a 1/2 wrench, install the provided 1-inch BALL.